New Cue Tip Installation Centering Tool

8/8/2018 9:11:14 PM

New Cue Tip Installation Centering Tool

I make a "cue tip centering guide" tool which I sell on eBay.

It helps me to put a 13 mm tip perfectly straight onto a 13 mm ferrule in less than 1 minute, after old tip cut off and cleaned. That is also true for any size cue tip. See my "Cue Tip Guide " on eBay (eBay user yesican6532).

Cue Tip Accessories Guide Tool
Installs your 13 mm cue tip onto your 13 mm ferrule perfectly straight in seconds. No cutting, trimming or sanding after installed. Made from recycled PVC materials. Other sizes available. Made in my workshop in the USA.

Instructions for using Cue Tip Guide.

Remove old cue tip and sand 13 mm ferrule flat and clean. Install guide over cue stick.

Add 1 drop of your favorite "Super Glue" to center of ferrule. Do not add too much.

Load 13 mm cue tip into guide with top of cue tip flush with top of guide.

Grip guide and hold finger firmly on top of cue tip.

Slide guide down approximately 1 to 1 1/2 inches while holding pressure on cue tip for 20 to 30 seconds then release and remove guide. Times may very depending on glue instructions. Follow directions on your glue bottle for drying time.

Cue tip is perfectly centered.

Guide separates into 2 halves in case you use to much glue and it leaks onto side of ferrule. I recommend doing a couple of dry runs before using the glue.

Source: ebay.com/itm/262871601368

user1533787786

New Cue Tip Installation Centering Tool

Title: New Cue Tip Installation Centering Tool
Author: user1533787786 (Jerry Black)
Published: 8/8/2018 9:11:14 PM
Last Updated: 8/9/2018 2:42:15 AM
Last Updated By: billiardsforum (Billiards Forum)